電纜在耐壓測驗中，咱們都是以為漏電流越小越好，因而許多的操作者都沒有對下限電流進行設定（一般出廠值設定為零），假如呈現上述的狀況，就存在誤判的也許，這時合理地設定下限就能處理此種狀況的發作。在耐壓測試儀不連接被測物的狀況下進行空測，此刻有一個很小的虛電流，咱們只需將下限電流設定為較空測電流值稍高就可以了。
當測驗回路呈現開路（如操作人員未能連接好被測物或是測驗線短裂等狀況），因為漏電流值小于下限設定，此刻耐壓測試儀就會呈現聲音的提示。那么咱們就要檢查一下是不是測驗線或是連接上呈現開路的狀況，然后保證測驗的有效性。
電纜工頻交流耐壓試驗裝置在作絕緣阻抗測驗中，也相同存在這么的疑問。關于一般而言，總是以為絕緣電阻越大越符合要求，但假如相同呈現耐壓測試儀與被測物之間開路的景象，那么也會存在相同的誤判景象。這時咱們就可以通過設定絕緣阻抗上限值來防止這種狀況的發作。
由電動調壓器和高壓試驗變壓器產生的0～30KV的高壓作為正極施加于試件上，根據預先設定的測試電壓對實際電壓進行調節，使測試電壓和實際電壓相同。
這時將一路電壓信號和多達6路電流信號通過遠程通訊電纜傳送至數據處理裝置，數據處理裝置對信號進行采集，放大及轉換，并對電壓信號與額定電壓進行比較，根據不同情況，電纜工頻交流耐壓試驗裝置啟動降壓與升壓繼電器，同時它還監測六路電流的大小，如果六路電流中任一路的泄漏電流超過額定電流，則微電腦啟動故障繼電器對應回路的指示燈亮，高壓測量裝置也發出聲。如果六路電流都正常，則試驗時間結束后，測試電壓降至零，可能要求打印出測試報告。絕緣靴手套耐壓測試儀可同時測量6個被試品技術！
